The loop mode allows the automatic repetition of Speedtest. The first test will start immediately after the loop mode has been initiated. Further tests will be started after the waiting time has elapsed. Tests will be performed until the configured number of tests has been reached. The loop mode can be stopped at any time. It needs to be explicitly pointed out that due to the loop mode it cannot be excluded that the tester is identified.

Please note that the loop mode consumes a huge amount of data. With high-speed connections 10 tests can consume 1GB or more. Therefore it is highly recommended to run the loop mode only with a true flat rate tariff where additional traffic des not generate additional costs. The loop mode also consumes a lot of battery power. Between the loop tests, the loop mode keeps GPS and the display active, thus the battery is drained much faster than in standby mode. In addition, tests also consume power. Therefore the loop mode should be used only if an extended power supply is available.